Those of you new to electronics or the functions and menus of an oscilloscope may be interested in a new tutorial which has been published by James the “Bald Engineer” using little Arduino and a Rohde & Schwarz RTM3004 oscilloscope. Check out the video below to learn more about learning the oscilloscope basics with an Arduino Uno.
“Learning to use a new oscilloscope can be daunting. In this video, I show 5 measurements you can make using just an Arduino as your DUT. Learn how to offset voltage, setup measurements, enable infinite persistence, save reference waveforms, AND trigger (and decode) serial signals. For this video, Rohde & Schwarz was kind enough to send me an RTM3004. This video is a follow-up from an ealier blog post which featured 6 scope measurements you can make with an Arduino.”
For more information on a few extra tips on using an oscilloscope with Arduino jump over to the official Bald Engineer website by following the link below. If you enjoyed this article you are sure to enjoy how to build your very own Arduino wind speed meter or anemometer project which is easy to build with basic Arduino skills.
Source: AB : Addhoms : Bald Engineer
Latest Geeky Gadgets Deals
Disclosure: Some of our articles include affiliate links. If you buy something through one of these links, Geeky Gadgets may earn an affiliate commission. Learn about our Disclosure Policy.